LIQUI MOLY – Engine Flush Plus 300ml – Remove Engine Sludge.
Engine Flush Plus is a specially formulated combination of additives and carrier fluid. In combination with the carrier fluid, the highly effective detergent and dispersant additives dissolve sludge and lacquer formers. All types of oil-soluble and oilinsoluble residues are brought into suspension and removed during the next oil change. An engine which has been cleaned of deposits and contamination and which is then filled with fresh oil not contaminated with old impurities can develop its full performance characteristics.
Combination of active agents made up of special additives and carrier fluid. Brings all types of oilsoluble and oil-insoluble residues into suspension and removes these from the oil circuit during the next oil change. Following this, the engine that has been cleared of deposits and contaminants and the fresh oil can then deliver its full performance.
Properties – gentle cleaning – rapid cleaning – does not attack common sealing materials – minimizes wear – simple to use without disassembly – optimal engine performance – highly economical – tested for particulate filters and catalytic converters – tested for turbocharger
| Technical data | |
| Color/Appearance | yellow, brown |
| Base | the additive, carrier liquid |
| Flash point | 63 °C DIN ISO 2592 |
| Pour point | -45 °C DIN ISO 3016 |
| Form | liquid |
| Viscosity at 40 °C | <7 mm²/s |
| Odor | characteristic |
For cleaning and flushing out the oil circuits in gasoline and diesel engines. Use dependent on the degree of contamination of the oil circuit. Can be safely used in vehicles with toothed belt running in oil. Not suitable for use in motorcycles with wet clutches!
300 ml sufficient for up to 6 l of oil. Add to the motor oil at operating temperature before the oil change. Then allow engine to idle for approx. 10 minutes. Then change the oil and the filter. Compatible with commercially available motor oils.
